Surface & Pendant 3535 Square Profile
NL-AP-3535-2M
A square surface / pendant profile for two lines of strip, with L, T and X connectors for continuous runs and shapes.
Specifications
Specifications from the DayTech LED cut sheet. Subject to change without notice.
| Part Number | Voltage | IP Rating | Colour | Length / Size | Power | Quote |
|---|---|---|---|---|---|---|
| NL-AP-3535-2M | IP20 | 2 m |
Clean Corners and Junctions with L, T and X Connectors
The 3535 takes L, T and X connectors for continuous runs and shapes, so one surface-mounted or pendant layout can turn corners, branch off and cross while keeping the same square 35 × 35 mm profile throughout.

Which Connector Do You Need?
| Connector | Part No. | Use |
|---|---|---|
| L connector | NL-AP-C3535-L | Corner run |
| T connector | NL-AP-C3535-T | Three-way join |
| X connector | NL-AP-C3535-X | Four-way join |
| 90° connectors | Please inquire | Inside / outside corners |
- Plan one L connector at each corner, a T where a run branches off and an X where two runs cross.
- Connectors are ordered separately from the profile.
Joining the Profiles
- 1Fit the Connector
Slide the connector halfway into the channel and lock it with the supplied screws.
- 2Add the Next Length
Slide the next channel section over the connector and tighten.
- 3Finish the Shape
Fit the covers and end caps to complete the shape.
Mounting the Shape
- Surface: fix the profile with the NL-AP-C3535 mounting clips.
- Pendant: hang it with the NL-AP-R60-HK hanging mount kit (pendant steps are on page 2 of the cut sheet).
What to Order
| Item | Part No. |
|---|---|
| 3535 square profile, 2 m (frosted or milky cover included) | NL-AP-3535-2M |
| L, T and X connectors | NL-AP-C3535-L / -T / -X |
| End caps, metal with screws | NL-AP-C3535-C |
| Mounting clips (surface) | NL-AP-C3535 |
| Hanging mount kit (pendant) | NL-AP-R60-HK |
From the DayTech LED NL-AP-3535-2M cut sheet. Connector quantities depend on your layout: send us a drawing and we'll put the list together.
Planning a Project with the 3535 Square Profile?
Tell us the lengths and layout and we'll quote the tape, channel, connectors and driver for each run.




