Pickup from our Mississauga warehouse · 5250 Satellite Drive, Unit 7 905-617-0298Cut Sheet LibraryCustomer Portal (Coming Soon)
Home / Videos & FAQ

Videos & FAQ

Installation videos and answers to the questions we get most about our products.

Videos

Watch and Learn

Installation videos are coming soon.
FAQ

Common Questions

Can't find your answer? Call 905-617-0298 or send us a message.

Can You Cut Tape and Channel to Length?

Yes. We cut aluminum channel and LED tape to length on request to make your installation easier. Add the lengths you need to your quote request.

What Is the Difference Between COB and SMD LED Tape?

SMD tape uses individual LED chips spaced along the strip, so you can see points of light unless the tape sits deep in a channel with a diffuser. COB (chip on board) tape has a continuous line of densely packed LEDs under a phosphor coating, giving a smooth, dot-free line of light even in shallow channels or without one. COB is usually the choice for coves, shelving and exposed lines; SMD remains a good, efficient option inside deeper channels.

Which Colour Temperature Should I Choose?

2700K and 3000K are warm whites that suit homes, restaurants and hospitality spaces. 3500K and 4000K are neutral whites often used in kitchens, retail and offices. Daylight (5500K and above) is crisp and cool, used for task, display and commercial lighting. Tunable white tape lets you adjust between warm and cool. If you're matching other fixtures in the space, use the same colour temperature as those fixtures.

What Do the IP Ratings Mean?

The IP rating describes protection against dust and water. IP20 is for indoor, dry locations. IP65 is protected against water jets and suits damp or covered outdoor areas. IP66 is protected against powerful water jets. IP67 is protected against temporary immersion, and IP68 against continuous immersion under the conditions the manufacturer states. Each product's cut sheet lists its rating.

Which Tape Can Go in a Sauna or Steam Room?

Our 2835 and 2216 sauna and steam tapes are sealed in a thick silicone jacket and rated to operate at up to 90 °C. The cut sheet recommends mounting them in the NL-AP-1715 channel, with the 24V driver located outside the hot room.

Do I Need a Driver for 120V Tape?

No. Our 120V COB tape and 120V RGB flex neon run directly on line voltage, so no low-voltage driver is needed. Because they are line-voltage products, they must be installed by a licensed electrician to the electrical code.

How Do I Size a Driver?

Multiply the tape's power per metre by the length of the run to get the total wattage, then choose a driver that is loaded to no more than about 80% of its rating. For example, a 5 m run of 320 Series COB tape at 8 W/m draws 40 W, so a 60 W driver is a good fit. Every cut sheet lists the power per metre, and we're happy to check your driver sizing.

How Much Flex Neon Can One Driver Run?

It depends on the product, and every cut sheet lists it. For example, each full roll of 1616 Series Flex Neon (low, medium or high output) runs on a single 96W 24V driver.

Can I Pick Up My Order?

Yes. Orders are picked up from our warehouse at 5250 Satellite Drive, Unit 7, Mississauga. Call 905-617-0298 to arrange a time.