Single Colour Accessories Tape-to-Wire Lead · 100 cm
DT-100CM-8, DT-100CM-10
100 cm (3'3") lead to connect a cut reel to bare wires. Works with COB reels, FL-300 and FL-600 tape.
Splice this lead's bare wires to a longer low-voltage run (14–20 AWG).

Screw-terminal male DC plug (DC-PLUG-MALE) that turns bare low-voltage wire into a plug-in DC connection.

Screw-terminal female DC plug (DC-PLUG-FEMALE) that turns bare low-voltage wire into a plug-in DC connection.

Specifications
Specifications from the DayTech LED cut sheet. Subject to change without notice.
| Part Number | Voltage | IP Rating | Colour | Strip Width | Power | Quote |
|---|---|---|---|---|---|---|
| DT-100CM-8 | IP20 | 8 mm | ||||
| DT-100CM-10 | IP20 | 10 mm |
From Cut Tape to Power in Minutes
The Tape-to-Wire Lead clips onto the end of a cut piece of tape light and gives you 100 cm (3'3") of lead with bare wires at the other end. From there you can wire straight into a low-voltage power supply, or join the lead to a heavier-gauge wire run with the Compact Wire Splice Connector (DT-CWSC-2S-STR).
Pick the Right Lead
| Part No. | Tape Width | Works With |
|---|---|---|
| DT-100CM-8 | 8 mm | 300 Series, 600 Series, 160 Series COB, 320 Series COB, 480 Series COB |
| DT-100CM-10 | 10 mm | 800 Series, 5730 strip |
- For wet or outdoor locations, see the IP65 and IP66 versions of this lead.
Clip It onto the Tape

- 1Cut the Tape
Cut the tape at one of its marked cut points so the copper pads are clean and square.
- 2Line Up the Polarity
Slide the cut end into the connector with the tape's + and − pads lined up with the lead's + and −.
- 3Close the Clip
Close the connector clip over the tape so the pads make firm contact.
Option A · Wire Straight to the Power Supply

- 1Match the Voltage
Use a power supply with the same output voltage as the tape (12 V tape on a 12 V supply, 24 V tape on a 24 V supply).
- 2Connect the Bare Wires
Connect the lead's + wire to the supply's + output (V+) and the − wire to its − output (V−).
- 3Power Up
Switch on and check that the whole run lights evenly.
Option B · Extend with Heavier Wire

- 1Run Your Wire
Run a heavier-gauge low-voltage wire from the power supply to the tape location. The Compact Wire Splice Connector takes 14–20 AWG wire.
- 2Splice the Lead
Join the lead's + and − wires to the + and − of your wire run with the DT-CWSC-2S-STR Compact Wire Splice Connector.
- 3Connect at the Supply
Connect the other end of the run to the power supply's + and − outputs, then power up.
Before You Power Up
Important: Keep + to + and − to − from the power supply to the tape. Reversed polarity will stop the tape from lighting.
- Switch off power before connecting or disconnecting the lead.
- Mains wiring to the power supply must be done by a qualified electrician to local code.
From the DayTech LED single colour accessories guide. Not sure which lead or wire gauge you need? Send us your layout and we'll put the parts list together.
Planning a Project with the Tape-to-Wire Lead · 100 cm?
Tell us the lengths and layout and we'll quote the tape, channel, connectors and driver for each run.










