Single Colour Accessories DC Plug Male Connector
DC-PLUG-MALE
Male DC plug connector with + / − screw terminals. Screw in the bare wires of a Tape-to-Wire Lead · 100 cm (or any low-voltage wire) to add a male DC plug, then connect it to a DC female lead from the power supply.


Specifications
Specifications from the DayTech LED cut sheet. Subject to change without notice.
| Part Number | Voltage | IP Rating | Colour | Length / Size | Power | Quote |
|---|---|---|---|---|---|---|
| DC-PLUG-MALE | DC male, screw terminals |
Turn Bare Wire into a Plug-In Connection
The DC Plug Male Connector has + and − screw terminals on one end and a male DC plug on the other. Screw in the bare wires of a Tape-to-Wire Lead · 100 cm (DT-100CM-8 / DT-100CM-10), or any low-voltage wire, and the tape can plug straight into a DC Lead · 2 m with a female end (NL-DCFEMALE-2M) coming from the power supply. No soldering needed.
Tape to Power Supply

- 1Clip the Lead onto the Tape
Clip the Tape-to-Wire Lead onto the cut end of the tape, + to + and − to −. The Tape-to-Wire Lead page shows the clip-on steps.
- 2Wire the Screw Terminals
Put the lead's red (+) wire into the + terminal and the black (−) wire into the − terminal, then tighten both screws so the wires can't pull out.
- 3Wire the DC Lead at the Supply
Connect the bare wires of the NL-DCFEMALE-2M lead to the power supply's + (V+) and − (V−) outputs.
- 4Plug Together and Power Up
Push the male connector into the lead's female end, switch on and check that the whole run lights evenly.
Where It Helps
- The tape can be unplugged from its power lead without undoing any wiring.
- Works on any bare low-voltage wire, not just the Tape-to-Wire Lead.
- Need the opposite end? The DC Plug Female Connector (DC-PLUG-FEMALE) has the same screw terminals.
Before You Power Up
Important: Keep + to + and − to − at every connection. Reversed polarity will stop the tape from lighting.
- Use a power supply with the same output voltage as the tape (12 V tape on a 12 V supply, 24 V tape on a 24 V supply).
- Switch off power before plugging in or unplugging.
- Mains wiring to the power supply must be done by a qualified electrician to local code.
From the DayTech LED single colour accessories guide. Not sure which parts you need? Send us your layout and we'll put the parts list together.
Works with These Products
300 Series LED StripDC-PLUG-MALE
300 Series Bendable LED TapeDC-PLUG-MALE
600 Series LED StripDC-PLUG-MALE
800 Series LED TapeDC-PLUG-MALE
160 Series COB TapeDC-PLUG-MALE
320 Series COB TapeDC-PLUG-MALE
320 Super Slim COB Tape (5 mm)DC-PLUG-MALE
320 Series COB Tape (8 m, IP67)DC-PLUG-MALE
480 Series COB TapeDC-PLUG-MALE
2835 Sauna & Steam LED TapeDC-PLUG-MALE
2216 Sauna & Steam Tape LightDC-PLUG-MALE
Planning a Project with the DC Plug Male Connector?
Tell us the lengths and layout and we'll quote the tape, channel, connectors and driver for each run.




